Con-tech CS2000-QD Manual do Utilizador

INTELLIGENT LABEL SENSORSOPERATIONS MANUALCS2000 & CS2000-QDCS2000 & CS2000-QDCS2000 & CS2000-QD Control Technologieswww.con-tech.c

ACME LABELSACME LABELSACACME LABELSACME LABELSACME LABELSACME LABELS- 8 -OperationLabel Placement:For best results, position straight edge of label un

- 9 -OperationLED Functions: Yellow - comes on when label backing (web) is under the sensing area Red - comes on when output is active - NPN sinking

- 10 -Adjusting Label SensitivityOverview: The CS2000 will automatically adjust its label sensitivity, to the optimal setting, by simply depressing a

- 11 -Missing Label CompensationOverview: The CS2000 has the capability to detect a single missing label and output a stop pulse as though the label

- 12 -Program ModeEntering Program Mode: Program Mode is used to change any or all of the Operation Features. To enter Program Mode depress the push-

- 13 -SpecificationsGeneral:Power Supply...10-30 VDC, reverse polarity protectedPower Consumption..

- 14 -SpecificationsDimensions:CS20000.4411.20.6251.0025.40.62515.979.43.12550.8150.592.000.225.60.7519.10.5012.715.90.09SensingArea15.90.62576.23.00E

- 15 -Cleaning InstructionsCleaning Instructions:1.  Begin by removing the sensor lid's 4 screws with a 1/16" L wrench.2.  Gently lift the

- 16 -Warranty Terms & ConditionsWarranty: The CS2000 Label Sensor is warranteed for a period of two (2) years from the time of purchase. Control

Table of ContentsGeneral Information Features Diagram CS2000 Quick Start CS2000-QD Quick StartInstallation Mounting CS2000 Wiring CS2000-QD Wir

- 1 -General InformationFeatures:• 10 to 30 VDC input - reverse polarity protected• Fast RISC microprocessor controlled• Easy one touch setup - lab

- 2 -General InformationYellow LED:Indicates labelbacking (web)Push-buttonRed LED:Indicates output stateGreen LED:Indicates label+ label backingOption

- 3 -General InformationCS2000 Quick Start:1.  Connect red wire to supply voltage2.  Connect black wire to supply common3.  For NPN Output - connec

- 4 -General InformationCS2000-QD Quick Start:1.  Plug the CS2000-QD's male connector into a suitable 4 pin female connector2.  Connect brown w

- 5 -InstallationMounting:The CS2000 comes with 8 mounting holes allowing for many different mounting options. The holes are tapped for #8-32 screws a

- 6 -InstallationCS2000 Wiring:The CS2000 comes with an 8' - 4 conductor cable. Refer below for wire designations.RED = 10-30 VDCBLK = Comm

- 7 -InstallationCS2000-QD Wiring:The CS2000-QD comes with a 6" quick disconnect M12 - 4 pin male cable/connector (Turck P/N RS4.4T-2). Refer bel